The HS-2 Black Heat Shrink Splice Kit meets the definition of “goods put up in sets for retail sale.” As per GRI 3(b), classification is determined by the component, or components taken together, which confer on the set as a whole its essential character.

According to the ENs for GRI 3(b), “goods put up in sets for retail sale” refers to goods which: consist of at least two different articles which are, prima facie, classifiable in different headings consist of products or articles put up together to meet a particular need or carry out a specific activity and are put up in a manner suitable for sale directly to users without repackaging. The Explanatory Notes (ENs) of the HTS provide guidance in the interpretation of the Harmonized Commodity Description and Coding System at the international level. GRI 3(b) provides, in relevant part, that goods put up for retail sale shall be classified as if they consisted of the material or component which gives them their essential character. The General Rules of Interpretation (GRIs) of the Harmonized Tariff System (HTS) governs the classification of goods put up in sets for retail sale. Together they form an apparatus for making a safe, electrically sound connection. As the shrink tube is heated, it shrinks or reduces in size forming a tight insulating seal over the butt connector and wires. Once the connectors are crimped onto wires, the shrink tubes are slid over the connectors and heated. 8750 inches long with an outside diameter of. They are tube shaped and measure approximately. The butt connectors at issue are used to connect two conductors end to end. They are designed to make a solder-less termination on the ends of electrical conductors by use of a crimping tool.

Crimp connectors are manufactured in various sizes, shapes and characteristics (i.e. The Butt Connectors and insulation tubes are imported packaged together within a sealed clear plastic bag with installation instructions printed on the back. The HS-2 Black Heat Shrink Splice Kit consists of two #14 - #10 AWG (American Wire Gage) Crimp Terminal Butt Connectors and two insulating shrink tubes. A sample of the HS-2 was submitted with your ruling request. The merchandise under consideration is the HS-2 Black Heat Shrink Splice Kit from Boshart Industries Inc. Shepley: In your letter dated Januyou requested a tariff classification ruling. RE: The tariff classification of a heat shrink splice kit from Canada. 25 Whaley Avenue Milverton, Ontario N0K 1M0 For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.CLA-2-85:RR:NC:1:110 M80401 Mr. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. Not for consumer sale or use.ģM industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Contact customer service at 80 to request a certificate. Note: 3M products offered on a government contract that require country of origin representation must be certified by 3M Trade Compliance. Some products contain imported components. The designation that a product is Manufactured in the USA means the product undergoes substantial transformation in one of our U.S.

Heat shrink splice kit